EUR/USD – Euro starts week with losses, U.S banks closed for holiday

EUR/USD has lost ground at the start of the trading week. Currently, the pair is trading at 1.1477, down -0.39% on the day. There are no U.S events on the schedule, as U.S banks are closed for Columbus Day (however, stock markets are open). On the release front, German Industrial Production declined 0.3%, missing the estimate of 0.4%. The indicator has now declined four times in the past five months. In the eurozone, Sentix Investor Confidence dropped to 11.4 points, matching the estimate. On Tuesday, Germany releases trade balance.

In the U.S, the labor market remains hot, but September’s numbers were mixed. Nonfarm payrolls dropped sharply to 134 thousand, its smallest gain in a year. This was well short of the estimate of 185 thousand. However, one factor in the disappointing release is Hurricane Florence, which led to many employees being unable to report to work during the storm. Wages appear headed in the right direction – Average Hourly Earnings gained 0.3% in September, and are up 2.9% on a year-to-year basis. The unemployment rate fell to 3.7%, its lowest level since 1969. The mixed numbers put a slight damper on the odds of a December hike, which dipped to 76% after the job releases, down from 80% prior to the releases. A December rate hike would be the fourth this year, with the Fed expected to raise rates another three times in 2019.

Fed Chair Jerome Powell had a hawkish message for the markets last week. Powell said that interest rates were still accommodative, but were “gradually moving to a place where they will be neutral”. Powell said that extremely accommodative low interest rates were no longer needed, since the economy has strengthened. The hawkish comments helped push the U.S dollar higher on Wednesday. Analysts have noted that there is no precise definition of a neutral rate, but the Fed tends to use the 3 percent level as its yardstick. With the Fed expected to continue its gradual increase in rates, this level could be reached in 2019.

Italy and China drag markets lower

EUR/USD Fundamentals

Monday (October 8)

  • 2:00 German Industrial Production. Estimate +0.4%. Actual -0.3%
  • 4:30 Eurozone Sentix Investor Confidence. Estimate 11.4. Actual 11.4

Tuesday (October 9)

  • 2:00 German Trade Balance. Estimate 15.9B

*All release times are DST

*Key events are in bold

 

EUR/USD for Monday, October 8, 2018

EUR/USD for October 8 at 6:40 DST

Open: 1.1522 High: 1.1530 Low: 1.1471 Close: 1.1477

 

EUR/USD Technical

S1 S2 S1 R1 R2 R3
1.1190 1.1300 1.1434 1.1553 1.1637 1.1718

EUR/USD ticked lower in the Asian session. The pair has lost more ground in European trade

  • 1.1434 is providing support
  • 1.1553 is the next resistance line

Further levels in both directions:

  • Below: 1.1434, 1.1300 and 1.1190
  • Above: 1.1553, 1.1637, 1.1718 and 1.1840
  • Current range: 1.1434 to 1.1553

Content is for general information purposes only. It is not investment advice or a solution to buy or sell securities. Opinions are the authors; not necessarily that of OANDA Business Information & Services, Inc. or any of its affiliates, subsidiaries, officers or directors. If you would like to reproduce or redistribute any of the content found on MarketPulse, an award winning forex, commodities and global indices analysis and news site service produced by OANDA Business Information & Services, Inc., please access the RSS feed or contact us at info@marketpulse.com. Visit https://www.marketpulse.com/ to find out more about the beat of the global markets. © 2023 OANDA Business Information & Services Inc.

Kenny Fisher

Kenny Fisher

Market Analyst at OANDA
A highly experienced financial market analyst with a focus on fundamental and macroeconomic analysis, Kenny Fisher’s daily commentary covers a broad range of markets including forex, equities and commodities. His work has been published in major online financial publications including Investing.com, Seeking Alpha and FXStreet. Kenny has been a MarketPulse contributor since 2012.
Kenny Fisher

Latest posts by Kenny Fisher (see all)